From my experience:
- I will try to pull every single cycle tight, but not too tight.
- Don't worry about some cycle that might be a little loose, we will come back to fix it later.
- I will not repeat put line in bead that we need to come back to do something with that bead because it will make hole too tight and can not pass the line through, such as tail, ears, legs, etc.
- After the whole figure is done but still have some spots that are loose, just go back to put line through all those loose spots in zigzag motion. This way will not only make your figurine tighter, but also give strength to your charm.
Set as favorite
Bookmark
Email this
Hits: 898
Comments (1)
Subscribe to this comment's feed
written by Kachirat Karunamit, July 16, 2009
Thank you for this tip (to tighten our charm). I love to share one too. I found the way to fix one problem of the shortage of the line before the end of the section. At first I have to start all over again and use longer line. Now I think I can fix that problem. I tied knot at the end of the line. Don't leave line too short because you have to put both ends back into beads before you cut. Then use new line pass through bead(s)the same way as when you don't have that line shortage problem. Hope that everyone can understand me. Thank you to let me share.
-
- +0
-
-
Write comment
